11
IntelliJack - Self Diagnostic Headphone Jack
The IntelliJack self diagnostic headphone circuit detects when the headphone
jack has failed or been damaged. When a faulty headphone jack is detected, a
flashing “headphone” icon appears in the LCD display. It will remain on until a
new jack is installed and the icon reset.
To Replace the Intellijack:
1. Loosen the two screws evenly on the bottom of the IntelliJack module and
remove.
2. Carefully insert new IntelliJack module without bending contact pins.
3. Reset the Icon. Turn MYE Controller OFF then press and hold the “Power”
button for 3-4 seconds. When the icon appears again release the Power
button.
IMPORTANT NOTICE:
Defective user headphones may also trigger the faulty
headphone jack icon. It is important to audibly test the headphone jack prior to
replacement. If the problem was triggered by faulty headphones the icon may be
reset by plugging in known good headphones for at least 10 seconds or following
step #3 above.
