113903G -System Installation Manual
22
Positive Wire(s)
Included in the battery cable kit is a red wire that will connect the positive
conductor from the battery module to the inverter module.
1. Run the wire between the battery module and the inverter module to
get the approximate length required. Once the length is established,
cut and strip the wire. The wire should be stripped 3/8’ from both ends.
2. Insert the stripped wire into the battery positive terminal blocks in the
Inverter Module and the Battery Module. Follow the colors - red wire to
red terminal block.
3. Torque the battery terminal block to 10 inch pounds to secure the wire
into the terminal block.
4.
Repeat this process for additional Battery Modules.
Negative Wire(s)
Included in the battery cable kit is a yellow wire that will connect the
battery module to the inverter module.
1. Run the wire between the battery module and the inverter module to
get the approximate length required. Once the length is established,
cut and strip the wire. The wire should be stripped 3/8’ from both ends.
2. Insert the stripped wire into the battery negative terminal blocks in the
Inverter Module and the Battery Module. Follow the colors - yellow wire
to yellow terminal block.
3. Torque the battery terminal block to 10 inch pounds to secure the wire
into the terminal block.
4.
Repeat this process for additional Battery Modules.
