To select Video modes:
Use "Video-Mode" button to switch between these 3 videos:
PAL / NTSC / No OSD
To enter the menu:
Power on the TeleFlyTiny module. Hold the HOME button, then click the Video-Mode button to
enter the OSD menu. Use "Video-Mode" button to browse. Use HOME button to change values
or confirm. All changed settings will be saved after you use "EXIT" to quit menu.
To Discover your new GPS:
After you connect your GPS (sharing other GPS, or use a separate GPS), by default the TeleFlyTiny
will try use NMEA/38400bps to communicate with it. If your GPS use other protocol (UBX?) or
other baudrate, you need to discover your GPS once. Next time TeleFlyTiny will remember your
settings.
To discover your new GPS, hold "HOME" button and power on the TeleFlyTiny module. The
discovering procedure will display on the screen. Once it discovers your GPS it will display
"DONE" and current baudrate/protocol on the OSD screen. Power off, and power on again.
TeleFlyTiny will work with new settings.
Some AutoPilots send commands to their GPS after power on. In this case we need to discover
the GPS only after the system is stable. Do it in this way: Don't power on your TeleFlyTiny. Power
on your AutoPilot System. After about 5 seconds when the GPS is configured to a stable status,
hold the "HOME" button of TeleFlyTiny and power it on to start the GPS discovering procedure
How to update the firmware of TeleFlyTiny:
You need a USB-TTL module to update the firmware of TeleFlyTiny.
