3.4.4. FIXING THE PILLAR BRACKET
In order to properly cut the bracket start 12 mm from the hole center, as shown in the picture I.
Fix the motor to the bracket following the below procedure:
Linea di taglio
> 30
12 mm
pic
.L
•
Remove screw from plastic cap (picture L - A).
•
Fit the bracket to the motor (picture L).
•
Fit the pin (picture M).
•
Put the cap back and screw (picture N).
RH cap
= RH motor
LH cap
= LH motor
pic
.I
pic
.M
pic
.N
NB: Be carefull when fitting the cap. It has to match the proper motor.
8
rev01_22