www.hsdonline.co.uk
Adjusting the Stem
Follow these steps to adjust the metal detector’s stem.
1. Carefully turn the stem’s lock nut clockwise until it
loosens.
2. Lengthen or shorten the stem so when you stand
upright you are comfortable with the detector in
your hand, the search coil is level with and about
1/2 to 2 inches above the ground with your arm
relaxed at your side.
3. Carefully turn the stem’s lock nut counter clockwise
to lock it in place.
Adjusting the Search Coil
Loosen the knobs at the search coil’s end, then adjust the
search coil to the desired angle. (The search coil should be
parallel with the ground.) Tighten the knobs just enough to
keep the search coil from rotating or wobbling.
Installing Batteries
You need six AA batteries to power your detector (not supplied).
CAUTION:
• Use only fresh batteries of the required size and recommended type.
• Do not mix old and new batteries, different types of batteries (standard,
alkaline, or rechargeable), or rechargeable batteries of different capacities.
• If the detector is not to be used or to be stored remove the batteries to avoid
leakage.
1. If the detector is on, turn VOLUME on the control housing to
the OFF position, (The control clicks.)
2. Carefully press on the battery compartment cover and slide
the cover off in the direction of the arrow.
3. Insert the batteries into the compartment as indicated by the
polarity symbols (+ and -) marked inside the compartment.
4. Carefully replace the cover.
CAUTION:
• Always remove old or weak batteries if the unit is not used or is stored,
batteries can leak chemicals that can destroy electronic parts.
• Please change the batteries when LOW BAT light shows.
MYMD1061_Manual 19/7/16 13:02 Page 4
