UnixWare
Manual No. 771929
5-9
5
U
N
I
X
W
A
R
E
Adding System Drives
Use the UnixWare diskadd command to add System Drives to the primary
controller and to any secondary controllers. For more information, refer to
the UnixWare documentation on the diskadd utility.
☛
Note
No UnixWare Slice (UNIX file system) can be greater
than 2GB.
To Primary Controller
For the second and third System Drive of the primary controller, specify the
diskadd command as shown below (assuming the Mylex Disk Array
Controller is the first or only disk controller):
# diskadd c0b0t0d1 ##
(for the second System Drive)
# diskadd c0b0t0d2 ## (
for the third System Drive)
To Secondary Controller(s)
For the first and second System Drives of a secondary controller, specify the
diskadd command as shown below (assuming there is no other disk
controller):
# diskadd c1b0t0d0 ##
(for first System Drive of the second
controller)
# diskadd c1b0t0d1 ##
(for second System Drive of the
second controller)
Summary of Contents for Disk Array controller Software Kit 2.01
