2
Delivery
• Electric
photovoltaic excess-energy hot water system AC ELWA
• Connection
plug for control cable connection between AC ELWA and PLA Meter/Controller
•
IP21 cover
• Operating instructions
safety instructions
The installation must be carried out exclusively by the authorized expert.
When installing and connecting the relevant standards must be observed.
Warranty does not cover any damages caused by failure from disregarding these operating instructions.
A permanent earthing of the hot water tank is mandatory.
Never switch the unit on when the heating element is not surrounded and cooled by water.
The housing must not get damp or wet, it is only suitable for dry indoor areas. Danger of fatal electric shock!
Do not install device in ammonia-contaminated environments.
Do not install in dusty environment.
The ventilation holes of the housing
don’t have to
be closed.
Orientation of the device (horizontal heater, power cord below) must be maintained.
The PLA Meter/Controller must be mounted on a standard 35 mm DIN rail.
Avoid storage and operation temperatures > 40 ° C) and <5 ° C, do not expose to direct sunlight.
The AC ELWA must be connected to a nominal voltage of 230 VAC.
The circuit breaker of the grid connection for AC ELWA must be rated 13 A to 16 A, AC ELWA can be
adjusted accordingly.
The PLA Meter/Controller must be connected to 1 x 230 V AC or 3 x 230 VAC with Neutral. The allowed
fusing of the mains connection may be max. 65 A.
The safety thermostat responds to 98 +/- 3 ° C and the unit switches off permanently.
In commercial institutions, the accident prevention regulations of the professional associations must be
observed for electrical systems and equipment.
This unit can be used by children ages 8 and persons with reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they have been given supervision or instruction concerning the safe
use of the equipment and understand the resulting risks. Children should not play with the appliance.
Cleaning and user maintenance shall not be undertaken by children without supervision.
Liability and warranty exclusion
A liability and warranty exclusion applies to:
x
any damage or injury caused by improper handling or failure to observe the safety and operating
x
consequential damages
x
Unauthorized remodeling, disassembly or other interventions in the device, modification of the
product
x
Damage caused by calcium deposits on heating element.
