EN MY9081BK - User manual
9
2.1.3 Using the battery
The waiting time and calling time capacities specified by the phone
manufacturer are obtained under the ideal operating environment.
The actual values will vary with the network condition, operating
environment and operation method.
Please comply with the local regulations of disposing the battery
(such as recycling). Do not dispose it as household waste.
2.1.4 Battery level indicator
When the phone is on, the battery level indicator is located at the
upper right corner of the screen.
2.2 Connecting to the Network
2.2.1 SIM card
Please insert available Subscriber Identity Module (SIM) card into
your phone before using it. SIM card is supplied by your network
carrier.
All the information related to network connection is recorded on the
SIM card, so are the contact information such as names, phone
numbers and SMSs that you set to store on the SIM. You can take
out the SIM card from the phone and insert it into another GSM
phone to use it. Most new phones will recognize the SIM card
automatically.
Do not touch the golden contacts of the SIM card and place it away
from electricity and magnetism to avoid damage. You will not be
able to use the phone if the SIM card is damaged.
Note:
Before inserting and taking out the SIM card, always make sure
that the phone is switched off and disconnected from any
external power source; otherwise both the phone and the SIM
card may be damaged.
2.2. 2 Installing and uninstalling the SIM card
The SIM card usually comes attached to a special card. The metal
Should there be an emergency situation, contact crew member.
2. Getting Started
2.1Batteries
The battery is included in the package. It is not fully charged out of
factory but it may still be able to power on your phone. Please
completely use up the power of the battery and then charge it for at
least 12 hours with your phone turned off. You battery will reach its
optimal state after three cycles of charge and discharge.
2.1.1 Installing and uninstalling the battery
To install the battery, remove the back cover from the phone by
pressing firmly on the cover and slide it down. Align the golden
contacts of the battery to the contacts in the phone, and then
gently snap down the battery into place. Re-assemble the back
cover.
To uninstall the battery, flip the battery out from the bottom of the
battery.
2.1.2 Charging the battery
Plug the charger into the socket on the side of your phone.
Connect the charger to an AC wall socket. The blinking of the
battery level icon indicates the battery is being charged. When the
blinking stops, it indicates the charging is finished
During charging, the phone and charger will feel warm to the touch.
This is normal.
Warning:
The operating ambient temperature of the charger is 0
°
C-50
°
C.
Do not use it when the temperature exceeds this limit.
Use only chargers approved by the phone manufacturer to
ensure safety. Failing to comply with this will violate the terms
and conditions of the warranty.
