2
CONTENTS
•
Introduction
2
•
Installation and Safety
2
•
Accessories
2
•
Setting Up Your Tuner
3
Rear panel connections
•
Operating Your Tuner
4
Front panel controls
•
Remote Control Handset Operation
6
•
Installing and Replacing Batteries
7
•
System Operation with Smart My-Link
7
•
Trouble-shooting guide
7
•
FM Antennas
7
•
Specifications
7
INTRODUCTION
The Z132 is a full-function remote controlled AM/FM Tuner. It has
fixed-level low-impedance audio outputs to drive a Myryad
integrated amplifier or pre-amplifier - or other high quality
amplifier. A coaxial antenna socket is provided for a 75
Ω
FM radio
(band 2) antenna, and spring terminal block for an AM loop
antenna (supplied). In addition the Z132 has a Smart My-Link®
control input/output for communication with other Myryad
products.
The Z132 offers a range of expansion possibilities:
• The Smart My-Link® input can be connected to a Myryad
integrated amplifier or pre-amplifier so that the Z132 will
automatically be switched on or off when the amplifier is switched
on or off.
• The Smart My-Link® input/output can be coupled to other
Myryad products that can then be remote-controlled via the
Z132's infra-red receiver - or vice-versa.
• When linked via the Smart My-Link® to a compatible Myryad
integrated amplifier or preamplifier a number of extra features
become available which make the system as a whole easier and
quicker to operate – including using the Z132 as an alarm/wake-
up timer for the system.
INSTALLATION AND SAFETY
The Z132 generates very little heat but still requires some
ventilation. Do not place it on a rug or other soft surface into
which it could sink, obstructing the air inlets in its underside. Do
not allow any obstruction to the ventilation slots in the rear panel.
The Z132 should not be installed in a built in situation such as a
bookcase or rack unless proper ventilation is provided.
CAUTION: THIS APPARATUS MUST NOT BE EXPOSED TO
DRIPPING OR SPLASHING. OBJECTS FILLED WITH LIQUIDS
SUCH AS VASES MUST NOT BE PLACED ON THE
APPARATUS.
THE REAR PANEL POWER SWITCH DISCONNECTS MAINS
LIVE ONLY. THE POWER CORD MUST BE DISCONNECTED
FROM THE REAR OF THE APPARATUS, OR THE WALL
SOCKET, TO PROVIDE TOTAL ISOLATION. ONE OR OTHER
OF THESE CONNECTIONS MUST BE READILY ACCESSIBLE
WHEN THE APPARATUS IS IN USE.
Do not remove the cover, or attempt to modify or repair any item
yourself. Refer all servicing to a qualified technician.
ACCESSORIES
Your Z132 is supplied with the following accessories:
• Separate mains power cord to suit country of sale
• My-Link interconnect (0.5m RCA-RCA)
• MSR2 remote control handset
• Two AAA batteries for handset (not in some countries)
• MSR2 System Remote Control Owner’s Manual
• Wire 300
Ω
FM antenna for high signal strength areas
• Balun (matching adaptor) for connection of 300
Ω
FM antenna
• DIN-DIN coax adaptor for use with Balun
• F-type coax adapter (North America only)
• AM loop antenna
