26
27
17. If your blinds use tilt
cords, cut one string from
the tilt mechanism (Fig.
2.17), and tie a small over-
hand loop knot (Fig. 2.18).
Slide the loop through the
hook on the bottom of the
manual switch (Fig. 2.19).
Reattach your cord’s
tassel to the end of the
string.
CAUTION
STRING CUTTING:
By cutting the string from your
tilt mechanism, you will not be able to reinstall
your original tilt mechanism. If you plan on replac-
ing the original tilt mechanism at a later time,
simply use another piece of string for Step 17.
Fig. 2.19
Fig. 2.18
KIT INSTALLATION:
We recommend installing all
MySmartBlinds automation kits before begin-
ning to pair your blinds to the app. This will
make the pairing process quicker and simpler.
NOTE
18. If applicable, replace the
valance or trim over your
headrail.
CHARGING YOUR BLINDS:
If you are not installing
a solar panel, your MySmartBlinds battery pack
will need to be charged periodically. Connect the
MySmartBlinds charging cable (sold separately)
to the micro USB port on the bottom of the man-
ual switch (Fig 2.20).
NOTE
Fig. 2.20
