NATIVE-C1
T
ECHNICAL
R
EFERENCE
M
ANUAL
V1.0
Q
UICK
S
TART
- 11 -
3.3.2.
Hot-Swap
The
NATIVE-C1
supports hot-swapping, which means that hot-swap-capable modules can be
inserted or extracted during normal system operation without affecting other modules.
Make sure to follow the procedure
exactly
to prevent the module or the system from damage!
Insertion of a hot-swap-capable Module
•
Ensure the module supports hot-swapping
•
Ensure that the hot-swap-handle of the module
is in “unlock”
-position (pulled out)
•
Push the module carefully into the dedicated connector until it is completely inserted
•
The blue HS-LED turns solid on
•
With pushing the hot-swap-
handle to “lock”
-position, the HS-LED starts blinking and
the IPMI-Controller of the
NATIVE-C1
backplane
detects the board
•
If the information provided by the module is valid, the
NATIVE-C1
backplane
enables
payload power and the blue HS-LED turns off
Extraction of a hot-swap-capable Module
•
Pull the hot-swap-handle
in “unlock”
-position
•
The blue HS-LED starts blinking
•
The IPMI-Controller of the
NATIVE-C1
backplane disables payload power
•
The HS-LED turns solid on
•
Pull the module carefully out of the
NATIVE-C1
