7
N.B.: Make sure you do not glue the keypad flex underneath the keypad support.
N.B.: In the event that the keypad is not positioned correctly, peel it off right away with extreme care
and repeat the positioning.
N.B.: It takes up to 24 hours for the keypad to stick completely. During this time, do not expose the
helmet to atmospheric agents.
•
Line up the keypad flex connector to the e-box making sure that the letter “n” is pointing as shown
in Fig. 6.
•
Gently position the connector in its seat until it is all the way in (Fig. 7).
•
Connect the battery to the wiring system (Fig. 8).
•
Switch on the N-Com system (press “ON” for about 2 seconds) to verity its proper operation.
N.B. If the system does not work, remove the flex and repeat the previous operation, making sure
that the “n” is positioned as in Fig. 6.
Fig. 6
Fig. 7
Fig. 8
•
Secure the keypad flex in the specials stop (Fig. 9).
•
Position the e-box in its seat, arranging the keypad flex cable so that it does not interfere with the
positioning of the e-box, as illustrated in figures 10-11-12.
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
•
Position the left loudspeaker
in its seat, inserting the
cable in the special groove.
If necessary, secure the
earphone using the adhesive
supplied
as
standard
equipment (Fig. 13).
