19
Put the system in affiliation mode (press the “on” button until the LEDs
start to flash quickly).
With the helmet in affiliation mode, press both buttons “
” and “
” at
the same time for 2 seconds and release them when you hear a beep.
The system will emit a special beep to confirm the operation
5.3.
Cell phone functions
To carry out operations involving a cell phone, the same cell phone has to
be affiliated beforehand and connected to the Bluetooth Kit MULTI. When
the telephone is connected to Bluetooth Kit MULTI, the connection is shown
on the cell phone display (symbols vary depending on the phone used, for
examples earphones, auto, Bluetooth logo, etc.). Connection occurs
automatically when the system is turned on. Nevertheless, you can connect
or disconnect from the helmet (see the commands table below) or from the
cell phone.
Answering a call
Press any button briefly when you hear the ring
tone.
Hanging up/rejecting
a call
To end a call or reject an incoming call, press the
“on” button and keep it pressed for about 2
seconds (until you hear a beep).
N.B.: Cell phones affiliated in HSP (Headset
profile) mode do not allow calls to be rejected
Vocal call
To make vocal calls (in case of cell phones that
allow it) or give other vocal commands, press
the “on” key and keep it pressed for about 2
seconds (until you hear a beep)
Summary of Contents for bluetooth kit multi
Page 1: ...EN SAFETY AND INSTRUCTIONS FOR USE ...
Page 37: ...37 ...
Page 38: ...38 ...
Page 40: ...Printed on recycled paper Bluetooth Kit MULTI 01 06 2016 16 40 00 ...