26
Pre-selecting the
Mono cable
Put the system in affiliation mode by pressing
the “on” button and keeping it pressed until the
LEDs start flashing (starting with the system
turned off). Press the “
” button for 2 seconds
(beep).
Please refer to the list of Multimedia Wire and Multimedia Wire2 cables and
the possible connections on the website www.n-com.it
10.
CONNECTION TO OTHER AUDIO PERIPHERALS
Connect the 3.5 mm 4-pole
connector of the Multimedia
cable to the input connector.
Connect the other end of the
cable to the audio device.
A colored band on the cable
indicates the connector to hook
up to the audio peripheral.
When listening to an audio source connected via a Multimedia Wire or
Multimedia Wire2 cable, you can turn the audio source off and turn it back
on directly from the helmet:
Turning off the audio
peripheral
To turn off the audio peripheral, press the “
”
button and keep it pressed for about 2 seconds.
Turning on the audio
peripheral
To turn off the audio peripheral, press the “
”
button and keep it pressed for about 2 seconds.
Summary of Contents for bluetooth kit multi
Page 1: ...EN SAFETY AND INSTRUCTIONS FOR USE ...
Page 37: ...37 ...
Page 38: ...38 ...
Page 40: ...Printed on recycled paper Bluetooth Kit MULTI 01 06 2016 16 40 00 ...