EN
10
3.3.
Installing the microphone – jet helmets or flip-up helmets
Set up the microphone by inserting the clip that holds it in place, being careful to position it
correctly. (Fig. 11)
Note
: The flat part of the clip has to face upward when the microphone is positioned as shown in Fig.
11.
Position the microphone on the left side of the helmet, screwing the screw into the small frame.
(Fig.12 a/b) Make sure that the fluorescent band is facing the inside of the helmet.
On certain helmets, the housing for the microphone rod must be created by cutting out the helmet
border gasket along the pre-cut area. (Fig. 13)
3.4.
Installing the microphone – full-face helmets
Take the polystyrene cheek pad (left-hand side) and position the microphone in its housing, as
shown in fig. 14, making sure that the fluorescent band stays facing the inside of the helmet. (Fig.
15)
Secure the microphone to the cheek pad using the “microphone securing stickers”, see Fig. 14.
Fig. 14
Fig. 15
Fig. 11
Fig. 12a
Fig. 12b
Fig. 13
Summary of Contents for BX5
Page 2: ......
