17
•
Attach the wrench (fig. 11.6.1 position D) release the screws used for fastening
the indexable inserts (fig. 11.6.1 position C)
•
Indexable inserts (fig. 11.6.1 position B) replace with new, different, or just turn
them to use all cutting edges.. Attention! Considering the specific shape, focus on
this operation.
•
Indexable inserts must be appropriately fastened (fig. 11.6.1 position C).
•
Assemble the guiding plate set according to chapter 11.5
Fig. 11.6.1
12.
Maintenance and operation
Maintenance of machine B10 ELECTRA does not require any special tools and it is
very simple. Keep the machine clean and replace the lubrication grease in the
machine gearbox every 1000 working hours. This operation must be performed solely
in authorised service N.KO Machines.
Regularly check the supply power cable. In case of damage have it replaced in an
authorised service shop authorised to perform the such repairs. Contact your supplier.
When using the B10 Electra with or without the B-Dock accessory, we strictly recommend
to instal the protection felt plug into the headstock. The felt plug ord.No. 25315 is needed
to buy separately as a accessory. The plug protects the auxilliary bearing and the gear
against to be damaged.
A
B
C
D
