5
The bottom mark on the scale corresponds to a bevel height of approx. 1mm. It is recommended to
establish the exact chamfer height using a test job.
Graduated Collar:
On assembly, the device is adjusted to zero position. Zero position means a bevel height of 0.
Cutter Head 45 ° and radius 2,5
Cutter Head only for 6
0°
For very quiet operation and high stock-removing capacity the device has been equipped with triple milling heads, with
3 cutting inserts each. These cutting inserts have 3 cutting edges. They are the actual tools for bevelling and
deburring. Depending on the material they can be used for machining steel, aluminium, aluminium alloys and plastics.
Suitable for machining chamfers of
Cutting inserts seize: 13,47 x 3mm / PM25 M coated .
Cutter Head with Radius 2,5 Cutting Insert
For bevelling and deburring, use the 2.5 mm radius cutter head, Prod.-No. 25202
together
with the cutting insert Prod.-No. 25205.
Suitable for steel of up to 600N/mm²
Note: When inserting the milling head with radius, the supporting plate must be rotated to achieve the correct position
(compare 4.1).
Prior to machining steel and aluminium or aluminium alloys, it is recommended to spray the cutting edges with cutting
oil-adhesive-foam spotty in order to achieve enhanced machine ability of the edges and higher durability of the cutting
inserts.
