Nabco GT-710, Manual

Rev. 9-24-14 

Part #15-10683

www.NabcoEntrances.com 

GT 710-8710 Swing Door System Low Energy Operator

Install the First Half of Swing Arm 

5-17

3.►

Go to the top edge of the Swing Door. Measure:

X

0 inch Reveal (Straight Arm):

•  11/16 inch from the top edge of the Swing Door down to the center of the Swing Door. 

X

Reveals greater than 0 inch (L-Shape Arm):

•  1-9/16 inch from the top edge of the Swing Door down to the center of the Swing Door.

X

New dimension not shown (L-Shape Arm):

•   8-7/8 inch = New dimension

4.►Mark a Horizontal line to cross the Vertical line. This is the center of the first Sex Bolt hole.

Dim A

Center mark for

fi rst Sex Bolt Hole

DN 1088

Straight Arm

w/zero Reveal = 11/16”

L-Shape Arm

w/other Reveals = 1-9/16”

Center Pivot

Buƒ /Off set

(Inner Edge of Door Jamb)

Buƒ  Hinge

LED

TRANSFORMER

O F F

12

AUX

PWR

4

J2

3

J5

AC IN

F2

SW2

SW1

F1

RELAY

RELAY

J4

TDAS

SIGNAL

INPUT

TDPG

LCHK

CLOSE

Fuse 1: 0.5A 24 VA

C

STOP

OPEN

BCHK

CURRENT

LIMIT

MOTOR

J1

R28

MAGNUM 

4A

Fuse 2: 5A 120/24

0

Capacitor

MOV

ON

BACK

CHECK

SWITCH

DOOR

CLOSED

SWITCH

FOR

XXX HAND

UNITS

Figure 5-7 

Measure to Mark the First Screw Hole

5.b.b: Secure the Track to the Swing Door

1.►Butt the Track against the Swing door by aligning the first Sex Bolt hole with the measured Mark.

Ensure the Track is square and level. 

2.►

Use the Track as a Template to mark the second Sex Bolt hole. Set aside.

3.►

Drill (2) 3/8 inch bolt holes all the way through the Swing door.

4.►

Go to the back of the Swing door. Insert each Sex Bolt into the drilled holes.

5.►

Go to the front of the Swing door. Butt the Track against the Swing door. Align the Sex Bolt holes.

a.  If the wall/frame is not straight, vertical, plum etc., install (1) Spacer (21-0902) behind the 

Track only if Reveal has a variance of zero to 1/4 inch and a Straight Arm is being installed. 

b.  A Spacer is used to prevent the Swing Arm from hitting the lip of the GT-710 Header only (the 

GT-8710 Header does not have a lip).

c.  If a Spacer can not be obtained, a couple of washers can be used.

6.►

Secure the Track to the Swing Door with (2) 1/4-20 x 2-1/4” Screws. Please see 

Figure 5-8

.

DN 1099

Spacer

Sex Bolt

Track

1/4-20 x 2-1/4”

Phillips Head Screw

Swing Door

A Spacer is only used with 

a Straight Arm that is being 

installed on GT-710 Units

to prevent the Swing Arm 

hi  ng the Lip of Header.

Figure 5-8 

Secure the Track to the Swing Door