GT 710-8710 Swing Door System Low Energy Operator
Part #15-10683
Rev. 9-24-14
6-20
Install the Second Half of Swing Arm
DN 1104
5/16-24
Set Screw
3/8”-24 Lock Nut
Swing Arm
(
Low Profi le)
Threaded Rod
3/8”-24 x 1-1/4”
Socket Screw
.405 Washer
5/16-24
Set Screw
Swing Arm
(Standard Profi le)
Threaded Rod
3/8”-24 x 1-1/4”
Socket Screw
3/8”-24 Lock Nut
.405 Washer
Figure 6-5
Connect the Swing Arm to the Threaded Rod
6.b.b:
Inswing Arm
1.►Remove the first 1/4-20 x 2-1/4” Screw (closest to the Pivot Door Jamb) that is used to secure the
Track to the Swing door. Please see
.
a. That side of the Track will hang down.
2.►
Close the Swing door to allow the Wheeled Roller (located at the end of the Swing Arm) to butt
against the Swing door.
3.►
Pull the Swing Arm to the Swing door, then raise the Track.
4.►
Secure the Track to the Swing door with (1) 1/4-20 x 2-1/4” Screw.
DN 1105
21” Track
Inswing Arm
Wheeled Roller
Wheeled Roller
Inswing Arm
“0” Reveal
12-1/4” Track
Figure 6-6
Insert the Swing Arm into the Track
