14 of 26
GT 710-8710 OPUS Low Energy Swing Doors Quick Set-Up and Parts Guide
www.NabcoEntrances.com
P/N C-00178
Rev 12-20-17
DN 1099
Spacer
Sex Bolt
12.25” Track
1/4-20 x 2-1/4”
Phillips Head Screw
Swing Door
0 - 1/4” Reveal using a Straight Arm
To prevent the Swing Arm from
hi ng the Lip of Header, a Spacer is
used with 12.25” Tracks.
Figure 18
Secure the Track to the Swing Door
CHAPTER 7: INSTALL THE TOP HALF OF SWING ARM
SECTION 7 .1: Set Pre-Load
Proper Preload is critical for the Control/Operator to open/close the Swing Door correctly.
Power must be turned OFF during the Swing Arm installation.
1. Locate pre-load numbers 1-4 on the Bottom of the Operator Spindle. Pre-load numbers 1-4 mark the correct installation
position for pre-load.
DN 1120
Pre-Load Numbers
Pre-Load Mark
22
11
4 4
33
2 2
1 1
3 3
44
PRELOAD: 1 NOTCH = 18 DEGREES
Figure 19
Pre-Load Numbers
2. Slide the Swing Arm onto the Operator Spindle by aligning the appropriate pre-load number to the pre-load mark on the
underside of Swing Arm:
RH Outswing
LH Outswing
RH Inswing
LH Inswing
RH Inswing-0 Reveal
LH Inswing-0 Reveal
1
2
3
4
4
3
3. Please see Figure 20, or Figure 21, or Figure 22.
RIGHT HAND
OUTSWING
LEFT HAND
OUTSWING
DN 1113
10-25x.25”
Set Screw
10-25x.25”
Set Screw
DN 0020
DN 0021
MAIN SPEED
LA
TCH SPEED
For Commercial or Industrial Use
Manufactur
ed
Pedestrian Commercial & Indust
rial
Commande de porte pietonniere
a
60 Hz
S82 W18717 Gemini Dr
ive
Muskego, WI 53150 US
A
Pedestrian Door Operator
usage commercial ou indu
st
riel
TL
Model No
.
NABC
O
ENTRANCE
S
GYRO
TEC
H
11
5 Vo
lts
Amp
s
Ma
x
501
S
in
LISTED
BACK CHECK
2
1
2
1
4
3
3
4
MAIN SPEED
LA
TCH SPEED
BACK CHECK
For Commercial or Industrial Use
Manufac
tu
re
d
Pedestrian Commercial & Indus
tria
l
Commande de porte pietonniere
a
60 Hz
S82 W18717 Gemini Dr
ive
Muskego, WI 53150
US
A
Pedestrian Door Operator
usage commercial ou industr
ie
l
TL
Model No.
NABC
O
ENTRANCE
S
11
5 Vo
lts
Amps Ma
x
501
S
in
LISTED
2
1
4
3
2
1
3
4
Figure 20
Preload: Outswing Arm
WARNING
CAUTION
