12 of 31
GT1175 Slide Door Opus Control Wiring and Programming Manual
www.NabcoEntrances.com
P/N C-00391
Rev 8-11-21
CHAPTER 7: SENSORS WITH MONITORING
X
It’s best to setup the controls and have the doors operating as desired before connecting safety sensors. This way any
settings that typically need to be copied are already established.
X
Door mounted safety sensors should be connected to the control running the door which those sensors apply to.
X
When monitored sensor wiring is different between controls, you want to avoid monitoring settings from being copied to
the other control, say “no” to “copy data” when exiting programming.
X
Overhead safety sensors are not ideal on low-energy pairs or whenever doors are often used manually. But when used
(common in full-automatic doors), as above, monitoring should only be active on the control that the sensor is connected
to, typically the “Type 2” Control. Avoid copying data.
CHAPTER 8: PROGRAMMING MENUS
SECTION 8.1: Base Settings
Base Setting
Setting Category
Menu Item
Default
Action
Operator Type
►
GT-300/400/500 Swing
►
GT-1175 Retrofit Slide
►
GT-1175 Opus Slide
►
GT-710 Swing
GT-710
Swing
►
Select (1175 Opus Slide) when VS-150 Operator is used.
►
Select (1175 Retrofit Slide) when U01-U19 type Operator is used.
Door Hand
ATTENTION:
Bi-Parts are set up
as Left Hand
►
Left
►
Right
Left
From the Exterior Side of Building, determine which Handing to
enter: Left or Right
RIGHT HANDING
DN 1326
LEFT HANDING
EXTERIOR SIDE OF BUILDING
►
When used with VS-150 Operator: Slider Handing can also be selected on the Opus Control by the
direction of the motor rotation during door opening (CW, CCW) .
Reduced Stroke
►
Yes
►
No
No
To reduce opening, manually move door and push YES
SECTION 8.2: Movement Settings
Movement Setting
Parameter
Range
Default
Description
Open Speed
0 - 7
3
The higher the number the faster the Door opens
Back Check Speed
0 - 7
3
Sets door speed during Back Check
Back Check Range
0 - 7
3
Slide Door: 1" to 13-3/4" of Fully Open
Close Speed
0 - 7
3
The higher the number the faster the Door closes
Latch Check Speed
0 - 7
3
Sets door speed during latch check
Latch Check Range
0 - 7
3
Slide Door: 1" to 13-3/4" of Fully Closed
Open Timer
0-10, 12, 15,
20, 25, 30
2
Hold Open time after Door reaches Full Open and activation signal is no
longer present.
Reaction Power
0 - 7
3
Determines how fast the door reacts to a reactivation when closing.
Open Recycle Sens
0 - 7
3
Recycle detection Sensitivity. Determines how much force is exerted during
opening or closing cycle.
►
“0”= most sensitive
►
“7” = least sensitive
Close Recycle Sens
After Open Recycle
Slow Open
Slow Open Determines what happens after a recycle during Opening cycle.
Slow Open = Door stops then slowly opens.
Stop = Door stops then slowly closes.
Stop
