BATTERY CHARGE LEVEL GAUGE
The battery charge level gauge works with a microprocessor. The led display
indicates the charge level:
4= maximum charge, 3= 3/4 charge, 2= 2/4charge,1= 1/4 charge, 0 = batteries
discharged (flashing).
IMPORTANT: the brush motor automatically turns off a few seconds after the
flashing "0"appears. The remaining charge can be used to terminate drying
operations before recharging.
SQUEEGEE
The squeegee is supplied separately, dismantled from the machine, for packing
reasons. It must be installed as illustrated, threading the retaining pin into the
squeegee column. Put the vacuum tube into its sleeve.
The rear rubber, during operation, must be slightly and uniformly bent back about 5
mm. along its entire length. It may be necessary, to increase curvature of the rubber
in its central section, to slope the squeegee body backwards. This is done by
rotating adjustment unit (1) counter-clockwise. To increase curvature on the outside
sections of the rubber just rotate adjustment unit (1) clockwise.
REGULATION SQUEEGEE HEIGHT
The squeegee has to be regulated depending on the wearing of the rubber. To adjust
this:
•Rotate the wing nuts clockwise to lift the squeegee and counter clockwise to lower
it.
Note: The right and left wheels must be regulated the same amount so that the
squeegee works in parallel to the floor
