10
Lowering the floor tool
Fig.16
After preparing the floor (see previous section), we are now ready to set the controls to suit the cleaning conditions.
Before any settings can be applied, ensure the brush deck is lowered.
Move the Floor tool lever (see fig.16), to it’s lower position (see fig.17).
Note:
The machine will still reverse with the floor tool in the lowered position, this could possibly damage the
blades. Raise the floor tool before reversing.
Fig.17
Machine Operation
Pre-scrub mode
The TT Range have been designed to cope with a variety of floor types and different levels of soiling.
On heavily soiled floors use a ‘double scrub’ technique.
First pre-scrub the floor with the floor-tool in the raised position, allow the chemical time to work, then scrub the area a
second time with the floor-tool lowered.
The clean-water / chemical mix is
dispersed via ‘THRU-FEED’ system.
The waste water is then retrieved by
the floor-tool.
Overlap the scrubbing path by 10cm
to ensure an even clean (Fig 14).
If streaking occurs, wipe the floor-tool
blades clean (Fig 15).
Floor tool in use
Fig 15
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
AND RELEVANT SAFETY SIGNS ARE DISPLAYED.
!
!
Numatic part (629044) Wet Floor sign
(available if required)
Pre-cleaning advice.
Before performing the cleaning operation, place out
appropriate warning signs and sweep or dust-mop the floor
(Fig 13).
Fig 13
Fig 14
Summary of Contents for TT 1117 / 100
Page 26: ...26 TT 1117 TT 1120 120V 60Hz DRW 12545 A02 25 10 2012...
Page 27: ...27 Notes...
