12
ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED
PRIOR TO ANY MAINTENANCE OPERATION
!
!
After use, empty waste-water tank using
emptying hose
and flush-out with clean
water (Fig 19).
A
Remove the two hoses to disconnect the separator from the
machine (Fig 20).
Lift off the separator. The separator has a sealing-rubber
which should be examined at every clean-down (Fig 21).
Rinse using clean water.
The TT Range has been designed with ease of use in mind, this included easy stripping-down and cleaning.
Remove the filter fitted into the separator and flush with clean water (Fig 22)(Fig 23).
Placed into the top tank is grey filter basket, clean and flush with clean water (fig 24) (Fig 25).
A
Regular Maintenance
The Bottom (Clean Water) tank is attached to the chassis and should only
be removed by a competent service engineer (Fig 26).
Clean by flushing with clean water if required.
Excess water can be drained using the clear dump hose fitted to the rear
of the machine.
Located under the left hand side is a clean water filter, ensure the clean
water tap is turned off before removing this filter (Fig 27).
Clean and flush with clean water if required.
Fig 19
Fig 20
Fig 21
Fig 22 Fig 23
Fig 26
Fig 24
Fig 25
Fig 27
Summary of Contents for TT 1117 / 100
Page 26: ...26 TT 1117 TT 1120 120V 60Hz DRW 12545 A02 25 10 2012...
Page 27: ...27 Notes...
