8
Machine Set-Up
Fitting the Floor Tool
The floor tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off
feature if the floor tool gets snagged, whilst in transit.
Raise the floor tool for transit or lower for cleaning operation using the lifting
handle fitted to the back of the machine (Fig 11).
For fitting the floor tool blades (See Page 10)
Note:
It is easier to fit the floor-tool if the weight of the machine is resting on the brush. Ensure the brush is fitted first.
Fig 11
Fig 10
Fig 9
Fit the floor tool and retain using
the detent pin (fig 9).
The lifting strap is held by a
detent pin (Fig 10).
Note:
Raise floor-tool again before driving to the cleaning area
Tipping the Brush Deck
To tip the deck into the down position
(Operating mode). Press in the brush
deck locking bar (Fig 7) and rotate the
brush deck (Fig 8).
To change to brush deck up position,
(Transit mode) simply lift the deck and
the sprung loaded locking bar will active
to hold the deck up.
Fig 8
Fig 16
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
!
Fig 7
Summary of Contents for TT 1117 / 100
Page 26: ...26 TT 1117 TT 1120 120V 60Hz DRW 12545 A02 25 10 2012...
Page 27: ...27 Notes...
