15
Emergency-stop button and horn
Machine in use
The TTV-678 is equipped with an
electronic braking system.
Simply lift your foot from the accelerator and the machine will stop.
In an emergency, strike the emergency-stop isolator button
The machine will be disabled.
To reset, turn isolator button clockwise (see Fig.26).
After resetting the emergency stop button, to restart the
machine ,turn the ignition key to the off then the on
position again.
The
horn
is located on the right-hand side of the operator
control panel (see Fig.26a).
Fig.26
Fig.26a
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
AND RELEVANT SAFETY SIGNS ARE DISPLAYED.
NOTE:
Care must be taken to reduce speed when
cornering or when manoeuvring around obstacles..
!
!
To operate, select forward or reverse, press the accelerator
pedal. Vacuum pick-up, water-flow and chemical-dose will
turn on automatically and the machine will move forward.
The clean water / chemical mix is dispersed evenly via
‘THRU- FEED’ scrubbing brushes.
The waste water is then retrieved by the suction floor-tool
(see Fig.27). Overlap each scrubbing path by 10cm to ensure
an even clean.
Do not operate the machine on inclines that exceed 11%.
If streaking occurs wipe floor-tool blades clean (see Fig.28).
On heavily soiled floors use a ‘double scrub’ technique.
First pre-scrub the floor with the floor-tool in the raised position,
allow the chemical time to work then scrub the area
a second time with the floor-tool lowered.
Fig.27
Fig.28
Summary of Contents for TTV 300T
