d) Press the PLAY button
- The first programmed track starts to play
NOTE:
- Disc and track numbers cannot be selected during
programmed play.
- The DISC SKIP button cannot be used during pro-
grammed play.
HOW TO CHECK THE PROGRAM
CONTENTS
1. Press the STOP button.
2. Press the REVIEW button to view the contents of
the program memory.
3. Each time the REVIEW button is pressed, the
contents are shown in the DISC NUMBER, TRACK
NUMBER and TIME displays.
4. If the REVIEW button is pressed and held down,
the display shows the entire contents of the program
memory, in numerical order, one selection at a time.
Adding Selections To a Program
When adding new selections to a program after
programmed play is completed, or after checking the
program contents.
1.Press the STOP button.
2.Press a DISC NO. button to select a disc number.
3.Press the “>>I” or I<<” button to select a track
number.
4.Press the PROGRAM button.
To Cancel Programmed Play
1. Press the STOP button to end programmed play.
2. Press the CLEAR button to clear the program
memory.
-The MEMORY indicator goes OFF.
3. During programmed play, if the CLEAR button is
pressed, programmed play will end and normal play
continues from that point.
NOTE:
The program memory is also cleared if the CD
changer’s power is switched off.
NAD
10
GB
IN CASE OF DIFFICULTY: A TROUBLE-SHOOTING GUIDE
If you have followed the instructions and are still having difficulty operating your compact disc player, locate the
PROBLEM in the left hand column below. Check the corresponding POSSIBLE CAUSE and REMEDY columns to
locate and solve the problem.
PROBLEM
POSSIBLE CAUSE
REMEDY
No power when the
Poor or no power plug connection
Insert the power plug firmly into
POWER button is set
at the AC outlet.
the AC outlet.
to ON.
Disc play does not start.
The disc is loaded upside down
Reload the disc with the label
side UP.
The disc is too dirty
Clean the disc.
No Sound.
Incorrect audio cable connections.
Connect the CD changer to the
amplifier/receiver correctly.
Incorrect amplifier/receiver operation
Make sure that the input
selector on your amplifier or
receiver is set to CD.
Sound Skips.
The CD changer is subject to vibration
Change the installation location.
or physical shock from external sources.
Programmed Play does not
The CD chager is in the normal play
Press the STOP button, then
function.
mode.
enter a program.
Remote Control does not work
Batteries in Remote Control handset
Replace batteries.
have expired.
Object obscuring remote sensor on
Remove any objects directly in
the player
front of the player.
A"humming" sound can be heard.
Loose cable connections.
Check the cable connections
particularly the phono
connecting cables
