10
BLUETOOTH
DECOUPING BLUETOOTH SOURCE DEVICE
:
Press and hold the
Bluetooth
source button on the remote for 5
seconds. The source LED will start blinking as a sign that the
AMP1 is ready for coupling another Bluetooth device. this
procedure will erase all couplings ( it is possible to couple with
more then one device for easy access.)
SPECIAL FUNCTI
ON
S
TV CONNECT
TV Connect is a new software enabled feature that allows the AMP1 to
provide the sound for your TV. TV Connect enables the AMP1 to "listen"
to the mute and volume control commands from most common
Samsung and Sony TV remote controls. Additionally, the AMP1will
automatically power up to OPTICAL D1 source upon detection of digital
TV output signal at OPTICAL D1.* If you have a remote control that does
not send IR commands (eg, a Smart remote), some newer TVs also
support IR learn so you can force the television to broadcast IR
commands to your product, thus using your TV remote control to
control your NAD Amp1. Find it in the list under setup on your TV to use
this feature. Check the manual for your TV if in doubt.
The digital inputs are capable of handling audio signal in PCM-format.
check your source signal type to make sure it is in the right format. in
some cases you need to switch on the optical output of your TV. if
you're not sure it's in the right format please check your source device
manual or contact your dealer of the manufacturer/Distributer of the TV.
AUTO SENSE
(APU Auto Power Up)
When in standby mode, NAD Amp1 will by default start up
automatically once you start playing music from your source. (notice,
there is No Auto sense on Phono/Turntable input)
Bluetooth will Auto connect to already paired devices.
AUTO SENSE
Uitschakelen:
You can turn the Auto sense OFF if you wish. Press and hold the
Power button on the remote for 5 sec.
The Power indicator will flash fast for 2 sec. and the NAD Amp1‘s
APU is disabled. When NAD Amp1 is powered on again it works
normal again with APU function.
If you do not want auto sense on the inputs at any time, you
should always power the amplifier off manually with the remote
(and hold the power button for 5 seconds when doing so)
AUTO STANDBY (A
PD A
UTO
POWER DOWN
)
The NAD Amp1 will automatically go into standby after 15 minutes if
no music is playing. Timeout for Bluetooth connection loss with
Bluetooth device is also 15 minutes
this function is implemented by EU law for reducing power
consumption. based on the EU act of J
anuar
y
2013
to reduce and
limit powerconsumption on inactive products
.
OTHER FEATURES
Initiate pairing of your Bluetooth device with
the AMP1
by following
below procedure.
1
Using your iOS, Android or compatible device, go to
Settings
$
Bluetooth and then scan for Bluetooth devices.
2
Select the unique device ID of your
AMP1
among the available
devices listed in your Bluetooth settings. Pair or connect together your
AMP1
and the Bluetooth device.
3
Upon successful pairing of your Bluetooth device and
the AMP1 LED
wil stop blinking
