NAD C 352, Owner'S Manual

3

ENGLISH

FRANÇAIS

DEUTSCH

NEDERLANDS

ESP

AÑOL

IT

ALIANO

POR

TUGUÊS

SVENSKA

IMPORTANT SAFETY INSTRUCTIONS

19 Damage Requiring Service

- Unplug this product from the wall outlet and refer servicing to qualified service personnel under the

following conditions:

a)

When the power-supply cord or plug is damaged.

b)

If liquid has been spilled, or objects have fallen into the product.

c)

If the product has been exposed to rain or water.

d)

If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by

the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive

work by a qualified technician to restore the product to its normal operation.

e)

If the product has been dropped or damaged in any way.

f)

when the product exhibits a distinct change in performance-this indicates a need for service.

20 Replacement Parts

- When replacement parts are required, be sure the service technician has used replacement parts specified by

the manufacturer or have the same characteristics as the original part.  Unauthorized substitutions may result in fire, electric shock, or

other hazards.

21 Safety Check

- Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to

determine that the product is in proper operating condition.

22 Wall or Ceiling Mounting

- The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

WARNING

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. THE LIGHTNING

FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE

PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE” WITHIN THE PRODUCT’S ENCLOSURE THAT MAY BE OF

SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS. 

THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO THE PRESENCE OF

IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE  LITERATURE ACCOMPANYING THE

APPLIANCE

CAUTION

Changes or modifications to this equipment not expressly approved by NAD Electronics for compliance could void the user’s authority

to operate this equipment.

CAUTION REGARDING PLACEMENT

To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer dimensions including projections) equal

to, or greater than, shown below.

Left and Right Panels : 10 cm

Rear Panel : 10 cm

Top Panel : 50 cm

IMPORTANT INFORMATION FOR UK CUSTOMERS

DO NOT

cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable

is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. If, nonetheless,

the mains plug is cut off, REMOVE THE FUSE and dispose of the PLUG immediately, to avoid possible shock hazard by inadvertent

connection to the mains supply. If this product is not provided with a mains plug, or one has to be fitted, then follow the instructions

given below:

IMPORTANT

DO NOT

make any connection to the larger terminal which is marked with the letter ‘E’ or by the safety

earth symbol or coloured GREEN or GREEN AND YELLOW.

The wires in the mains lead on this product are coloured in accordance with the following code:

BLUE - NEUTRAL

BROWN - LIVE

As these colours may not correspond with the coloured markings identifiying the terminals in your plug, proceed as follows:

The BLUE wire must be connected to the terminal marked with the letter ‘N’ or coloured BLACK.

The BROWN wire must be connected to the terminal marked with the letter ‘L’ or coloured RED

When replacing the fuse, only a correctly rated and approved type should be used, and be sure

to re-fit the fuse cover.

IF IN DOUBT CONSULT A COMPETENT ELECTRICIAN

This product is manufactured to comply with the radio interference requirements of EEC DIRECTIVE 89/68/EEC and 73/23/EEC

NOTES ON ENVIRONMENTAL PROTECTION

At the end of its useful life, this product must not be disposed of with regular household waste but must be returned to a collection

point for the recycling of electrical and electronic equipment. The symbol on the product, user's manual and packaging, point this out.

The materials can be reused in accordance with their markings. Through re-use, recycling of raw materials, or other forms of recycling

of old products, you are making an important contribution to the protection of our environment. 

Your local administrative office can advise you of the responsible waste disposal point.

Model No. :________________________Serial No. :_________________

 6/16/2005  5:17 PM  Page 3