background image

®

ASYNCHRONOUS USB DAC MODULE

Mounting Instructions

MOUNTING INSTRUCTIONS FOR THE C 375BEE

The DAC Module is compatible with C 375BEE.  Using the supplied flexible flat 
cable (FFC), DC power connector and screws, the DAC Module can be installed 
in a C 375BEE by undertaking the following procedure.

Note that if the C 375BEE has a PP375 Phono Preamplifier Module already 
installed, the DAC module and the PP375 can be linked together using the other 
supplied FFC.

STEP 1

Pre-install the requisite cables to their respective connector points on the DAC 
Module as shown.  Connect the FFC to the DAC Module’s PP375 IN only if the 
C375BEE has a PP375 already installed.

STEP 2

Make the following connections:

DC POWER connector from DAC Module to corresponding P216B in 
C375BEE’s main board.

FFC from DAC Module’s ANALOG OUT to P213B on C375BEE’s main board.  

If the optional PP375 module is installed: FFC from DAC Module’s PP375 IN 
to the corresponding FPC (flexible printed circuit) connector of the PP375 
module.

Ensure good harnessing by flexing and safely contorting the FFC and 
DC POWER connectors.

STEP 3

Remove the dummy cover at the back of the C375BEE and install in its place the 
DAC Module. Use the supplied screws to fix into place the DAC Module.

3

2

1

IMPORTANT!

The DAC module is only compatible with C 375BEE units that have the 

0.5W standby

 logo on their rear panels. 

Reviews: