ENGLISH
6 ETHERNET/LOCAL AREA NETWORK (LAN) PORT
•
LAN connection must be setup for wired connection to be
established. Set up a Wired Ethernet broadband router with
broadband internet connection. Your router or home network
should have a built-in DHCP server to consummate the connection.
•
Using a standard straight-through Ethernet cable (not supplied),
connect one end of the Ethernet cable to the LAN port of your wired
Ethernet broadband router and the other end to CS1’s LAN port.
NOTES
• NAD is not responsible for any malfunction of the CS1 and/or the
internet connection due to communication errors or malfunctions
associated with your broadband internet connection or other
connected equipment. Contact your Internet Service Provider (ISP) for
assistance or the service bureau of your other equipment.
• Contact your ISP for policies, charges, content restrictions, service
limitations, bandwidth, repair, and other related issues pertinent to
internet connectivity.
7 SETUP
•
The Setup button is used to restore your CS1 to its factory default
settings. It is not recommended to factory reset your CS1 unless
necessary.
•
Initiate factory reset when everything else fails and the unit may not
be able to recover.
•
The Setup button is also used to enable and establish Bluetooth
connection.
RESTORING CS1 TO FACTORY DEFAULT SETTINGS
a
At operating mode, press and hold rear panel’s SETUP button for at
least 10 seconds or until the front panel blue Power Indicator turns off.
Release hold of the SETUP button.
b
Wait for the CS1 to automatically power up again.
c
Power Indicator will turn red and then alternate flashing of red and
green (hot spot mode). The CS1 is now restored to its factory default
settings.
IMPORTANT
Restoring CS1 to factory default settings will delete all applicable
configured or saved settings.
BLUETOOTH CONNECTION
There are two methods to establish Bluetooth connection – Bluetooth
Pairing and NFC.
BLUETOOTH PAIRING
a
Press and hold rear panel SETUP button for 2 seconds and release.
Power indicator will flash twice indicating that Bluetooth pairing is
enabled.
b
Using your iOS, Android or compatible device, go to Settings, Bluetooth
and then scan for Bluetooth devices.
c
Select the unique device ID of your CS1 (for example, NAD CS123e71d)
among the available devices.
d
Upon selection of “NAD CS123e71d”, a Bluetooth prompt similar to
below will pop up
e
Select “Pair” to complete Bluetooth pairing. Your Bluetooth device and
your CS1 are now paired.
Playback music from your Bluetooth device and the CS1 Power
indicator will briefly flash blue to indicate the source is now switched
to Bluetooth.
NFC (NEAR FIELD COMMUNICATION)
a
Turn ON the NFC function of your iOS or Android device.
b
Place your iOS or Android device on the top of CS1 and a Bluetooth
prompt similar to below will pop up
c
Select “Yes” to complete Bluetooth pairing. Your Bluetooth device and
your CS1 are now paired.
Playback music from your Bluetooth device and the CS1 Power
indicator will briefly flash blue to indicate the source is now switched
to Bluetooth.
8 USB C 5V DC IN
•
Connect corresponding end of the supplied AC Adaptor to CS1’s
USB C 5V DC IN and then connect the AC Adaptor plug to a mains
power source.
•
Before connecting the AC Adaptor plug to the mains power source,
ensure first that the other end of the AC Adaptor connected to
CS1’s USB C 5V DC IN socket is firmly connected.
•
Always disconnect the AC Adaptor plug from the mains power
source first, before disconnecting from CS1’s USB C 5V DC IN socket.
IDENTIFICATION OF CONTROLS
FRONT AND REAR VIEW
7
Summary of Contents for CS1
Page 1: ...Owner s Manual ENGLISH Endpoint Network Streamer CS1...
Page 9: ......
