Note
Macros are independent of the cur-
rently selected device.
rECOrding MaCrOs
To record a macro, simultaneously
press-and-hold for 3 seconds both the
[MACRO] key and the HTR 8 function key
to which you wish to assign the macro,
until the status LED turns green. The
macro button will also light up.
Press the sequence of function keys to be
recorded into the macro, being sure to
first press the requisite DEVICE SELECTOR
key for each function (you may switch
devices while recording the macro as
many times as necessary), allowing you to
create macro containing commands from
more than one DEVICE SELECTOR “page.”
When you have finished entering the
desired command sequence, press
[MACRO] again to store the macro; the
Learn LED and [MACRO] key illumination
will turn off.
Note
Each macro can store a maximum of
64 command steps. If you exceed this
number, the macro will be stored au-
tomatically after the 64th command
is added.
Example:
Record a Macro to the [0] key
to turn ON the NAD Receiver, turn ON the
DVD Player, Select Input 1 (Source 1) and
commence disc playback of connected
Source 1 device (as in the DVD player)
•
On the HTR 8, simultaneously press-
and-hold [MACRO] and [0] (numeric
zero); the Learn LED turns steady
green.
•
Press [AMP], press [ON]; press [DVD],
press [ON]; press [AMP], press [1]
(Input 1); press [DVD], press [
4
] (Play)
– the Learn LED blinks as each step is
added.
·
Press [MACRO] again to exit the
macro-record mode.
To clear a macro, perform the above steps
without entering any functions.
7
ENGLISH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ
HTR8_eng_OM_v03.indd 7
20/01/2012 1:46am
