DELETE MODE
The HTR 3 can store learned, copied, and “default library”
commands on any single key (The default library commands
are the pre-programmed NAD codes, such as the native NAD
receiver commands on the [AMP] “page.”).
You can delete commands by layers back “down” to the default
library command on any key, removing learned commands,
punched-through functions, and copied keys.
NOTE
The default library commands cannot be deleted, so
you need not worry that using Delete Mode might cause
irreparable changes.
To enter Delete Mode, simultaneously press-and-hold for 3
seconds both the desired key’s DEVICE SELECTOR key and the
[RTN] key, until the Learn LED turns green. Press the function
key whose command you wish to delete; the Learn LED
flashes; the number of times indicates which type of function
has become active - see the table below. Press the active
DEVICE SELECTOR key again to exit Delete Mode.
NOTE
You may delete multiple function-key commands on the
same DEVICE SELECTOR “page,” but to delete from more
than one DEVICE SELECTOR page you must exit Delete
Mode and then re-enter it on the required page.
Flashes
Command Type
1
Default Library Command
2
Copied Library Command
3
Learned Command
LOADING CODE-LIBRARIES
The HTR 3 can store a different library of default NAD codes
for each of its DEVICE SELECTOR “pages.” If the original default
library does not control your NAD CD player, DVD player or
other component, follow the procedure below to change the
code-library.
Begin by ensuring that the component you wish the HTR 3
to control is plugged in and powered-up (“ON,” not merely in
standby). To enter the HTR 3’s Library Mode, simultaneously
press-and-hold for 3 seconds both the desired DEVICE SELECTOR
key and the [AVPS] key, until the Learn LED turns green.
While keeping the HTR 3 pointed toward the component,
enter the first appropriate three-digit code-library number
from the table below and then press [OFF]. If the component
turns off, press [ENTER] to accept that code-library number
and exit the Library Mode. If the component does not turn off,
enter the next three-digit code-library number from the table.
EN
G
LI
SH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ
HTR3_eng_OM_v02.indd 7
7/8/07 22:03:27
