ENGLISH
15
Music Library
1 Reindex Library:
Scan for new files added to the Music Library
Other
1 Reboot:
Cycle power by powering off and powering back the unit
2 Factory Reset:
Restore to factory default settings
3 BluOS Upgrade:
Select “BluOS Upgrade” to initiate BluOS upgrade
mode. When “BluOS Upgrade” prompt appears, select “Yes” to start
BluOS upgrade process. Follow the display screen prompt to complete
the upgrade procedure.
System Info
Display information about the following parameters
•
Show current or detected information about
BluOS firmware version
,
IP Address
,
MAC Address Ethernet
and
MAC Address Wi-Fi
.
• Temperature Left/Temperature Right:
If the internal temperature
of either left or right amplifier channel reaches 91 degrees centigrade,
M33 will turn off automatically and a protect message will be shown in
the display. Once the temperature falls below 80 degrees centigrade,
M33 will turn on again and the protect message display will be cleared.
• Temperature Heat Sink Left/Temperature Heat Sink Right/
Temperature MCU/Temperature PSU:
Display temperature as
measured over Temperature Heat Sink Left, Temperature Heat Sink
Right, Temperature MCU or Temperature PSU
• Bridge Mode:
“On” or “Off” is shown depending upon the setting (ON/
OFF) of the Bridge Mode switch at the rear panel.
OPERATION
USING THE FRONT PANEL DISPLAY
Summary of Contents for M33
Page 1: ...Owner s Manual ENGLISH BluOS Streaming DAC Amplifier M33 NAD M33...
Page 23: ...ENGLISH 23...
Page 24: ...ENGLISH 24...
Page 25: ...ENGLISH 25...
