Power Amplifier Section
Continuous output power into 4/8 ohms
180W (17dBw)
(Minimum RMS power per channel, both channels
driven, With no more than the rated distortion)
Rated distortion
(THD)(20Hz –20kHz)
İ
0.004%
Channel Separation
ı
100dB
(MAIN IN, 60W Out at 8
,1k
shorted, 1kHz)
Clipping power, 1kHz
220W
(Maximum continuous power per channel)
Dynamic Headroom at 8 ohms
4.2dB
Dynamic power
8ohms
ı
280W
(Maximum short-term power per channel )
4ohms
ı
480W
2ohms
ı
785W
Damping factor
ı
150
Signal to noise ratio(refer 1W A-weighted)
ı
ı
100dB
Slew rate
ı
ı
20V/
ȝ
sec
T.H.D and SMPTE I.M.
İ
0.01%
(Distortion from 250mW to rated output)
IHF I.M. (CCIF IM) and T.I.M distortion
İ
0.005%
(From 250mW to rated output))
Input impedance
20k
//680pF
Input sensitivity
rate power into 8ohms)
r
o
F
(
1.38V
Power amp gain
29dB
Preamplifier Section
Input Impedance
single-ended input
150k
//500pF
SPECIFICATIONS
NAD M3 INTEGRATE AMPLIFIER
Note: Specifications are measured in accordance with EIA
Standard RS-490 (IHF A-202) for amplifiers
1-6
balanced input
120k
S)
