GB
28
SAFETY INFORMATION
NAD LINK
The S170's rear-panel NAD LINK OUT jack can relay remote-control commands to other products equipped
with an NAD Link (or compatible) input, sending out the same control codes it receives from the S70
remote handset via IR (infra red ). NAD Link thus creates a “hard wired” connection between the S170
and another NAD component, employing any coaxial cable terminated with RCA Jacks.
Similarly, the S170's NAD LINK IN jack can receive commands, from an external IR sensor, a radio-frequency
wireless "remote-extender" system, or from a hard-wired remote-room control pad from third-party
suppliers such as Xantach, Niles, or Russound. Commands received by the NAD LINK IN jack are also
relayed to the NAD LINK OUT jack, permitting pass-through command of additional components such as
a CD or DVD player. By “daisy chaining” the NAD LINK OUT from one component to the NAD LINK IN of
another, full-system control can be achieved.
NOTE THAT:
NAD Link permits some or all components to be located "out of sight" to IR-remote commands while
maintaining complete responsiveness.
A component receiving the same command simultaneously from its own front panel IR sensor and via NAD
Link may not respond correctly. Do not link components liable to "see" the same IR remote command at
the same time, as would be the case with components stacked or placed adjacently.
SYSTEM INTEGRATION (RS-232)
The S170's RS-232 port offers extensive integration to sophisticated media-system and home-automation
control, and permits full control of all of the S170's features. Using this port, the S170 can be connected
to any other device with an RS-232 port, such as a personal computer or a home automation system. Any
command or function that can be issued from the front panel or the S70 remote controller can be
performed via the RS-232 port, and information feedback of the S170's current settings, including
MultiSource status, is transmitted from the preamp's RS-232 port to the connected PC or device. The
S170's MultiSource features are thus also fully controllable via RS-232 command.
TECHNICAL DETAILS
The RS-232 port uses the following standard pin-out arrangement:
DB-9 Pin #
Function
2
Transmit Data
3
Receive Data
5
Signal Ground
NOTE
• A standard, "straight-through" serial cable (not a null modem cable) must be employed to connect the
S170 to a PC or other serial device.
• S170 serial communications must employ 8 data bits, no parity, and 1 stop bit; the data rate is 12000
bps (baud). (Some serial devices are unable to communicate at 12000 bps; a bit-rate converter to
convert S170 communications to 9600 bps is available as a separate accessory; contact your installing
NAD audio specialist.
A Windows 95/98/ME-compatible application for serial control of the S170 from a PC, as well as complete
details of the S170's serial-communications protocols, are available for download from the NAD website:
HTTP://WWW.NADELECTRONICS.COM
See your NAD installing specialist for more information.
