MODE:
The following backlight modes are available:
• Off:
The backlight will never come ON.
• Sense:
The backlight will only come ON if the light sensor detects low
light conditions. See also“SENSE LEVEL” discussion below.
• On:
The backlight will come ON any time a key is pressed.
SENSE LEVEL (Sen Lvl):
The point where the backlight comes ON in a
darkened room. To set this level, go to a dim area where you think the
backlight should be activated given such a dark environment condition.
Then, press [ENTER] at “B Light – Sen Lvl” menu. The display will show the
current sensitivity level. An example is below
If such sensitivity level is alright with you, press [ENTER].
Select “YES” to complete the setting of the sensitivity level.
LIBRARY
The HTRC 1 can store a different library of default NAD codes for each of
its DEVICE SELECTOR “pages.” If the original default library does not control
your NAD CD player, DVD player, or other component, follow the procedure
below to change the library code. Please refer as well to the table below for
a list of uploaded NAD Library Codes.
Example:
Load NAD DVD Player T 585 library codes to HTRC 1’s “DVD”
device.
1
Press [DVD] in the DEVICE SELECTOR page.
2
Press and hold [TUNER (10+/SETUP)] and [ENTER] buttons. Use [ ] to
scroll to “Library”.
3
Press [ENTER].
4
The library code for NAD T585 is “600”. Use [ ] to toggle to “600”. Press
[ENTER].
5
Use [
] to select between “No” (desired library code is not
uploaded) and “Yes” (desired library code is uploaded and saved to the
applicable device page.
NOTE
Instead of scrolling through the library list, you can also key-in directly
the library code based on the list of Library Codes below.
LIBRARY
CODE
NAD PRODUCT
DESCRIPTION
LIBRARY
CODE
NAD PRODUCT
DESCRIPTION
100
Receiver/Processor (Discrete
ON/OFF)
300
Tuner
101
Receiver/Processor (Toggle
ON/OFF)
301
L75, L76 Tuner
102
S170
302
L70 Tuner
103
L75
303
L53 Tuner
104
Second Zone Commands
(Zone 2)
304
L73 Tuner
3112
Zone 3
305
C425
4112
Zone 4
306
C445
105
L70
307
Txx5 Series Tuner
106
L76
400
Tape Deck B
107
118
401
TAPE Deck A
108
L53
500
TV 280
109
L73
501
MR13
110
Stereo Receiver / Amplifier
502
MR20
111
Stereo Second Zone
503
PMR45
112
Txx5 Series
600
T535, T562, T585, M55
200
CD Player
601
T550, L55
201
CD Player (old)
602
T512, T531, T532, T571, T572
202
5170, 5240, 5340
603
L70, L73 DVD
203
5325
604
L56
204
5060
605
T513, T514, T515, T517, T524,
T533, T534
205
M5
606
L53 DVD
LEARN
This function allows you to learn IR commands from another remote.
Example:
Learning “MENU” function from a TV remote control into the
MENU button of HTRC 1’s TV device.
Begin by positioning the HTRC 1 “nose-to-nose” with the source remote so
that the two devices’ infrared windows are about 2 inches apart.
1
Press [TV] in the DEVICE SELECTOR page.
2
Press and hold [TUNER (10+/SETUP)] and [ENTER] buttons. Use [ ] to
scroll to “Learn”.
OPERATION
USING THE HTRC 1 REMOTE CONTROL
43
EN
G
LI
SH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ
