6
7. IEC Power Cord Receptacle
This.is.used.to.connect.the.AC.power.source.to.your.equalizer..
Power requirements: 115VAC, 60Hz
CAUTION: For new installations and portable sound systems,
or in any situation in which the AC power is suspect, it is wise to
confirm appropriate voltage and line polarity BEFORE connecting
the instrument to the power source.
8. Fuse Holder
This.fuse.holder.contains.an.AC.primary.fuse..This.fuse.should.be.
replaced.with.the.same.type.fuse.when.this.is.blown.out..If.they.
continuously.blow,.stop.replacing.the.fuse.and.refer.servicing.to.
qualified.personnel..
CAUTION: After checking the AC supply voltage, be sure that the
correct fuse is in the fuse holder. A 20mm glass tube 500mA 250V
fast-blow fuse should be used.
9. Input/Output Connectors
Balanced.XLR.and.1/4”.TRS.Inputs.and.unbalanced.output.jacks.
for.line.level.operation..Line.level.signals.from.-.18dBu.to.+18dBu.
are.considered.normal..Do.not.directly.connect.microphones.into.
the.equalizers..Microphones.require.a.pre.amp..
Note: Only one input and one output connector should be used at
a time.
Rear Panel Controls & Connections
7
9
8
7
8
7
9
8
9
