background image

IMPORTANT SAFETY INSTRUCTIONS

WARNING

ATTENTION

RISQUE dE CHOC ELECTRIQUE NE PAS OUVRIR 

An equilateral tr

iangle enclosing a lightning flash/arrowhead symbol is 

intended to alert the user to the presence of uninsulated “dangerous 

v

oltage”

 within the product’

s enclosure which may be of sufficient 

magnitude to constitute a risk of electr

ic shoc

k.

An equilateral triangle enclosing an e

xclamation point is intended to aler

the user to the presence of impor

tant operating and service instructions in 

the literature enclosed with this unit.

When using this electronic device, basic precautions should always be taken, including the following: 
1.  Read all instructions before using the product.
2.   Do not use this product near water (e.g., near a bathtub, washbowl, kitchen sink, in a wet basement, or near a swimming 
 

pool, etc.).

3.   This product should be used only with a cart or stand that will keep it level and stable and prevent wobbling.
4.   This product, in combination with headphones or speakers, may be capable of producing sound levels that could cause 
 

permanent hearing loss.  Do not operate for a long period of time at a high volume level or at a level that is uncomfortable.  

 

If you experience any hearing loss or ringing in the ears, you should consult an audiologist.

5.  The product should be positioned so that proper ventilation is maintained.
6.   The product should be located away from heat sources such as radiators, heat vents, or other devices
 

(including amplifiers) that produce heat.

7.  The product should be connected to a power supply only of the type described in the operating instructions or as marked on the
 

product.  Replace the fuse only with one of the specified type, size, and correct rating.

8.   The power supply cord should: (1) be undamaged, (2) never share an outlet or extension cord with other devices so that the
 

outlet’s or extension cord’s power rating is exceeded, and (3) never be left plugged into the outlet when not being used for 

 

a long period of time. 

9.   Care should be taken so that objects do not fall into, and liquids are not spilled through, the enclosure’s openings.
10.   The product should be serviced by qualified service personnel if:
 

A. 

The power supply cord or the plug has been damaged. 

 

B.   Objects have fallen into, or liquid has been spilled onto the product.

 

C.   The product has been exposed to rain. 

 

D.   The product does not appear to operate normally or exhibits a marked change in performance.

 

E.   The product has been dropped, or the enclosure damaged.

11.  Do not attempt to service the product beyond what is described in the user maintenance instructions.  All other servicing should
 

be referred to qualified service personnel.

3

Summary of Contents for SPM-4250













Reviews: