Nady Systems ENC Duet, Owner'S Manual

5

5. Connecting the Audio Output

The Enc

-

DUET receiver provides both a fixed mic level 

BALANCED AUDIO OUTPUT 

XLR (14)

 for each channel and an adjustable line level 

A + B UNBALANCED AUDIO 

OUTPUT 1/4" JACK (13) 

which provides a mixed (summed) Ch A plus Ch B output sig-

nal. The mixed level from the 

A + B UNBALANCED OUTPUT

 is controlled by the rear 

panel 

VOLUME CONTROLS (6)

 for each channel.

(Note: As when making any connection, make sure the amplifier or mixing board 

volume is at the minimum level before plugging in the receiver to avoid possible 

sound system damage. Also make sure that the phantom power on the input of the 

mixer is turned OFF before making connection to the receiver.)

a.

Instrument Connection

 (using the WGT instrument transmitter)

Insert an audio cord with a 1/4" mono phone plug in the 

A + B 

UNBALANCED OUTPUT JACK (13) 

on the rear panel of the receiver. Plug the 

other end of the cord into an amplifier, effects, or mixing board. Adjust the

appropriate 

VOLUME CONTROL (6)

 for the channel being used on the Enc

-

DUET receiver clockwise to about 3/4 rotation, until the mixed volume level is

comfortable for your application. This setting is roughly equivalent to a direct 

instrument cord connection. Turning the volume up to maximum will provide

4dB gain over a cord. 

(Note: Since this a mixed output of Ch A & Ch B, both 

channels with be processed simultaneously by the amplifier and/or effects 

connected to, which may not be appropriate for your application.

b.

Microphone Connection

 (using the WLT transmitter with either a headset

or lavalier microphone or the WHT handheld microphone transmitter) 
For microphone use, either the 

BALANCED MIC AUDIO OUTPUT XLRs (14)

 or the 

1/4" line level A + B UNBALANCED OUTPUT (13)

 can be used. The XLR output 

is set at a non-adjustable microphone level, similar to hardwired mic levels.

Plug an XLR connector into either or both of the 

XLR OUTPUT JACKS

 on the 

rear of the unit and plug the other end into your amplifier or mixing board.

(Note: Make sure the phantom power on your mixing board is turned off 

and the volume is turned down when making connections.)

For your convenience, the XLR output levels are preset at the factory and

are not adjustable with the receiver volume controls. To use the 1/4"

 A + B 

UNBALANCED OUTPUT JACK (13),

 follow the instructions for the Instrument 

Connection (above), except start with the receiver volume at 1/2 MAX

and adjust the volume control for each channel until the mixed Ch A and

Ch B volume level is optimal. If the volume controls are set too high, you 

may overload your mixer or amp.