15
Cautions and Troubleshooting
Low or no audio
If you are not getting audio through the system, carefully re-check all setups. Especially
note that the receiver and transmitter must be set to operate on the same RF channel.
Make sure that the
Power Switch (2)
on the MGT-16 receiver is not in the second
position (audio muted/attenuated). The receiver’s
Audio Output (7)
is adjustable, so
make sure the
Volume Control (3)
is set properly.
RF Interference and Finding Open Channels
If you receive interference on a selected channel with the transmitter off, you must
reprogram the receiver and transmitter to a different channel.
To reprogram, you must first find an open channel. To do this, follow the operating
procedure outlined in
Selecting the MGT-16 Receiver Channel and IR Sync
on page
10. With the transmitter off, change the receiver
DIP Switches (4)
setting to one of
the 16 channels until you find one for which the
Signal LED (10)
doesn’t flicker or
light up. Also, for optimal interference-free operation, the Signal LED must not flicker or
light up on any of the three immediately adjacent channels, both above and below the
selected channel (i.e., a field of seven adjacent channels, with the chosen channel in
the middle, should all be clear). If operating multiple MGT-16 systems simultaneously,
repeat this procedure every time a new channel is selected, with all other transmitters
and receivers turned on.
It is important to note that wireless frequencies are shared with other radio services.
According to current FCC regulations, wireless microphone operation is not protected
from interference from other licensed operations in the band. If any interference is
received by a government or non-government operation and wireless microphone use is
deemed responsible for the interference, the wireless microphone must cease operation
or change frequencies.
Note: This requirement is applicable in the U.S. only.
Note: If the Signal LED is lit, this indicates good signal strength in operation. If the
Signal LED remains lit with the transmitter off, this indicates the presence of likely RF
interfering signals at that location. Should this occur, select a different channel.
Consumer Alert
Most users do not need a license to operate this wireless microphone system. Nevertheless,
operating this microphone system without a license is subject to certain restrictions: the system
may not cause harmful interference; it must operate at a low power level (not in excess of 50mW);
and it has no protection from interference received from any other device. Purchasers should also
be aware that the FCC is currently evaluating use of wireless microphone systems, and these rules
are subject to change.
For more information, call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC) or visit www.fcc.gov/
cgb/consumerfacts/wirelessmic_factsheet.html.
