6
Nady Systems Inc.
Speakers and Stands
To set up, fully extend the speaker stand tripod legs and tighten the base screw.
Extend the pole of the stand to the desired height and insert the safety pin completely
through the stand hole above the pole thumbscrew. Lower the pole so that the pin
rests on the holder and tighten the pole thumbscrew.
Setup the stands on a flat surface where the speakers will be located and not disturbed.
Place the speakers on the stands and position them as desired, and tighten the included
bolt on the speaker mount until secured to the pole. Note: facing the speakers towards any
of the microphones connected with the PAS-300BT will increase the chance of feedback.
Connect the speaker cables to the input jacks on the lower left front panel of both the Left
and Right speakers. Connect the other end of each cable to the corresponding Left and
Right speaker outputs on the rear panel of the PAS-300BT mixer section. Position the
length of the cables so they will not be a safety hazard to people.
WARNING:
Connect only the supplied speakers to the PAS-300BT. Never connect
additional passive speakers to the PAS-300BT.
Inputs
Connect all sound sources to the appropriate inputs i.e., microphones, keyboards,
CD players, karaoke machines.
When ready to operate, plug the AC cord into the power source. Make sure that the unit
is turned off before connecting to the AC power source to avoid possible loud transients,
which can damage your speakers or your ears. Before turning on, connect up the speakers
and all inputs and outputs desired and turn down the Master Volume.
INSTALLATION
