8
4.
Installation of NAF1000 pigtail cables
4.1 Installation of NAF1000 ready assembled module
Install the cage nuts,
leaving the top opening empty
.
Open the coil of the tail cable and straighten it. Be sure to make the necessary markings on the cable. The
cable comes with serial number and length markings.
Insert the tail cable through the frame, steering the cable into the cable guides on the right side of the
rotating frame. If you are installing multiple panels at the same time, you can push the ends of the cables
through the frame and cable guides at the same time. Do not attach cables to the cable guides, but try to
leave them as loose as possible so that the panels can be pulled out of the rotating frame, e.g. when
cleaning the connectors.
