Deep sleep function - on ** deep sleep function - off
entering the deep sleep mode, you can wake up and exit the sleep mode by pressing the button or the
serial port command .
Note: The deep sleep function is only valid for manual mode and TTL-232 serial port mode output
3.1.4 Light sleep idle time
When deep sleep is not enabled, you can also set the idle time of light sleep by scanning the following
setting codes .
Note : The light sleep function is only valid for manual mode and TTL-232 serial port mode output
Light sleep idle time - 0ms
**Light sleep idle time-500ms
Light sleep idle time-3000ms Light sleep idle time-5000ms
3.2 Command trigger mode
starts shooting and reading when it receives the trigger signal command sent by the host (that is, the
bit 0 of the flag bit 0x0002 is written with " 1 " ) ; , if the reading is successful, the reading module will
output the reading content through the communication interface and stop reading. If you want to start a
new reading, you need to resend the trigger command . If reading exceeds the duration of a single reading,
the reading will be terminated .
Command trigger mode
