SNR-CI-H Series
Network IP Cameras User Manual
12/ 32
The pictures can be saved via E-mail sending or FTP uploading. For snapping parameters, if the
number of pictures snapped at one time is set as 10, and the snapping interval is 1 second, that
means when there is an alarm, 10 pictures will be snapped and the interval between each picture
is 1 second.
[Linkage recording]
: W hen alarm is triggered, the device SD card will be driven to record images.
The record files can be saved via E-mail sending or FTP uploading.
After setting all the parameters, click
[save]
to make the parameters valid.
5.3.3 Network Failure Alarm
See below picture for the interface of IP camera “Network Failure Alarm”:
Set network failure alarm parameters here: detection on/off, linkage alarm, alarm output
duration, E-mail sending when alarm has been triggered, linkage snapping/recording, etc.
[Detection On/Off]
: enable or disable network failure alarm detection.
[Linkage Alarm output]
: enable or disable linkage alarm output
[Alarm Output Duration]:
Set the duration of the linkage alarm output after being triggered (in
seconds), the range of the duration is 0~86400s.0 means that there is no limit for alarm output.
[E-mail sending]
: Send network failure alarm information to users via E-mail, details about E-mail
setting please refer to
[Network Settings]
.
[Linkage Snapping]
: When alarm is triggered, the device SD card will be driven to snap pictures.
The pictures can be saved via E-mail sending or FTP uploading. For snapping parameters, if the
number of pictures snapped at one time is set as 10, and the snapping interval is 1 second, that
means when there is an alarm, 10 pictures will be snapped and the interval between each picture
is 1 second.
[Linkage recording]
: W hen alarm is triggered, the device SD card will be driven to record images.
The record files can be saved via E-mail sending or FTP uploading.
Note: W hen network failure occurs, E-mail sending and FTP uploading cannot be performed,
the pictures and recorded files will be stored in SD card. E-mail sending and FTP uploading will
resume after network is recovered.
After setting all the parameters, click
[save]
to make the parameters valid.
5.4 Network Settings
5.4.1 Basic settings
See below picture for the interface of IP camera “Network Settings”:
