SNR-CI-H Series
Network IP Cameras User Manual
8/ 32
it to turn to
[Liveview]
, the system time that has been automatically corrected by NTP server can
be displayed.
[System Information]
: Display device name, device number, etc. Device name can be user-defined.
[Reset]
: All device parameters (including network parameters, excluding physical address) will be
recovered as factory setting values.
[Reboot]:
Click [Reboot], the IP camera will restart automatically after 5 seconds.
[Upgrade]
: Click
“Review”
button, and select correct file of upgrade (kernel file, suffix.uot),click
[upgrade],
then you can upgrade your system, the completion rate will be displayed during this
process. After upgrade completes, IP camera will restart automatically. Re-log in device, enter
into system settings page, check to see whether the kernel edition is the upgraded edition. For
example: kernel edition of the current IP camera is (V2.2.1.2), the latest edition obtained from
supplier is (V2.2.1.3), then the kernel edition after upgrade should be V2.2.1.3.
Note: Don’t cut off the power and internet connection while upgrading.
5.2 Video Settings
See below picture for the interface of “Video Settings”:
Video interface of CCD models
[Video Name]
: the name of video channel, displayed at the bottom left of image(movable), maximum
characters allowed: 32.
[Title Overlay]
: display or not to display name, date, time, week and frame rate/bitrate of channels.
[Position Adjustment]:
Can adjust the display position of video title.
[Preferred and alternate streams]:
set up video parameters for preferred and alternate streams.
[Coding algorithm]
: H.264 and MJPEG.
[Definition]
: set definition of images, modes supported are:
PAL mode – four definition format: D1(704*576)/Half-D1(704*288)/CIF(352*288)/QCIF(176*144)
NTSC mode – four definition formats:
D1(704*480)/Half-D1(704*240)/CIF(352*240)/QCIF(176*120).
[Image Quality]:
users can choose the right quality according to their needs: Best, Good, Normal,
and the parameters can also be user-defined by checking
[advanced settings]
checkbox.
