Award BIOS Setup
SECTION 2 INSTALLATION
2.1 How to load Windows O.S.
There are two solutions for this :
a)
USB type external CD-ROM (see the above optional picture). Please use the legal copy of
Windows XP O.S. If you choose this way, you have to enter into the BIOS menu setup,
choose the USB CD-ROM as the primary boot up disk.
b)
Open up the rear cover from behind, find an IDE cable and a standard 4-pin power connector.
Connecting the IDE cable and 4-pin power connector to a standard 5.25” CD-ROM that you
prepare for the PPC. Enter into the BIOS menu, choose CD-ROM as the primary boot up
disk. Put the Windows O.S. into the CD-ROM, start loading the Windows O.S.
SECTION 3 TOUCH SCREEN DRIVER INSTALLATION
3.1 Touch screen driver
The touch driver was contained in the CD Disk came with the unit. There are two touch drivers.
One is E-T, one is S-M. Please choose E-T touch driver to load into the PPC. After loading the
E-T touch driver, you must perform a 25-point calibration on the touch. Please be sure that each
touch point must be calibrated one by one. After all of the 25 touch points were calibrated. The
touch driver is successfully loaded.
3.2 25-Point Calibration
Touch the center point of the blinking icon one by one until all 25 points were calibrated.
