Instruction
Manual
18
The backrest moves down alone
The supporting gas lifts are loose.
• In such a case, remove the gas lift from the lower part and loosen it (unscrew it) 2 turns and fix it again. Proceed the same way with
the second gas lift.
The back rest is blocked (it can’t be lowered nor raised up)
The gas lift activating pin does not activate the lever. Remove the lower side of the gas lift and tighten it (screw it 2 turns until you see
that the pin can activate the lever. Proceed the same operation with the second gas lift.
The up and down motor does not work
• Check if the power cable is disconnected, either from the wall socket or the control box.
• Check the power cable for any damage.
• Check all the plugs and connections.
• There are 3 possible components that may be faulty: the Space Ball System, the control box or the motor itself. Contact your dealer
to proceed accordingly.
10. Troubeshooting and service
Persisting problems
If the problem persists, contact your local distributor and provide the serial number and the model of the table, or a picture
of the typeshield.
This can be found on the typeshield, located at the backside of the table, inside the top frame.
Serial number
