Issue: January 2004
Page 16
14.3.6 CONTRAST.
This menu permits to adjust the contrast of the display. Pressing the
“
UP
” (9) or “
DOWN
” (11) key changes the current contrast. Pressing the
“
CENTER
” key (13) stores the contrast settings as a default value at
power on.
To escape from the sub-menu, press the “
LEFT
” key (10) once.
14.3.7 VERSION.
Selecting the “
VERSION
” sub-menu shows the serial number of the
recorder as well as current version of the software installed. The version
shown in this picture corresponds to the version for the “
FAT 16
” mode.
Turning on the machine in the “NFS” mode will show the “
NFS
” version.
To escape from the sub-menu, press the “
LEFT
” key (10) once.
14.4 TEMPLATES, “FAT 16” MODE ONLY.
The Ares -BB can store and recall 4 different templates.
To have an overview of the different sub-menu settings that can be
stored, refer to the menu tree at the end of this
manual. Only menu settings with a red square
against it can be stored.
To use a template, setup the machine as required, then go to
“
TEMPLATES
”, select “
STORE 1
” and press the execute key (13). The message “
DONE
” will appear.
If now any changes were made in the setup, you can go to “
RECALL 1
” and press the execute key
once again. This returns the machine to the settings stored in template 1.
Templates
Recall 4
Store 1
Store 2
X X X
ARES-BB
S/N : 123456789
Soft (FAT): Vx.xx
Audio board: 2
Software options:
#1 #2
Contrast
Current contrast = 32
Default contrast = 33
TEST 34