15
Nagra –
CLASSIC DAC
Remote control
The CLASSIC DAC comes with a RCU III remote control unit (RC-5). However,
you may also control it with the classic Nagra RCU or RCU II (RECS-80). Please,
see page 11 how to select RC-5 protocol or device channel.
Using a “universal remote” with the CLASSIC DAC
The CLASSIC DAC responds to IR (Infra Red) signals coded in Philips RC-5
format. The CLASSIC DAC is allocated a system number 19 for digital-to-analog
converter.
Should you wish to program your universal remote control, please use the
following table:
Code
Function
1 to 6
Input
A
to
F
32 & 33
Input change step-up or step-down
13
Mute
12
Standby
Burn-in period
In order to obtain optimal performance from the Nagra CLASSIC DAC, it is
preferable to leave the device switched on for about 15 minutes before use, so
that the internal components can reach their optimum operating temperature.
The Nagra CLASSIC DAC needs a running-in period. It will reach peak
performance after a few hundred hours operation (at least 400 hours).
Case cleaning
Clean the CLASSIC DAC casing using a soft, non-fluffy, slightly damp cloth. Do
not use any cleaning products which could have a corrosive effect.
3.
Input decrement
Input increment
Inactive
Mute
Operation LED
(will blink when a
button is pressed)
Standby
Input block
A to F
Inactive
